Ultralox® architectural powder coatings are organic coatings that must be regularly cleaned and maintained in order to ensure the decorative and protective properties of the coatings are retained. Records of all cleaning schedules and frequencies shall be kept and maintained by the customer according to the process outlined below and shall be available to Ultralox® upon request.
CLEANING METHOD
Usual maintenance of Products must adhere to the following steps:
• Clean using an appropriate cleaning product, as defined below.
• Rinse with clear water.
• Wipe with a soft cloth.
• All surfaces shall be cleaned using a soft cloth or sponge, and no cloth shall be harsher than natural
bristle brushes.
If the Product is subject to any hazardous and unusual environmental factors or is located within one (1) mile of the seashore, an estuary or marine environment, Ultralox® must be consulted on an individual project basis for best maintenance practices.
CLEANING PRODUCTS
Before cleaning, the customer must consult and adhere to the underlying instructions contained within
the Product Data Sheet available online at Ultralox.com.
Usual maintenance cleaning may be done using water with a mild detergent (pH 5 to 8).
If atmospheric pollution has resulted in heavy soiling of the coating, some stains or marks may require
stronger domestic products, such as alcohol, petroleum spirits, white spirits or bleach diluted to five
percent (5%). In this instance, the customer must rinse the coating immediately after using the cleaning
product.
In no circumstance shall any abrasive cleaner, polish or cleaners containing ketones or ether be used.
FREQUENCY
For all Products located within one (1) mile of the seashore:
• Customer shall clean the Product six (6) times per year.
• The cleaning cycle shall commence within two (2) months of installation.
• Cleaning shall be conducted in intervals not to exceed two (2) months.
• Customer shall maintain fully documented records throughout the Warranty term.
For all Products located more than one (1) mile of the seashore:
• Customer shall clean the Product four (4) times per year.
• The cleaning cycle shall commence within three (3) months of installation.
• Cleaning shall be conducted in intervals not to exceed three (3) months.
• Customer shall maintain fully documented records throughout the Warranty term.
ADDITIONAL FACTORS
Damage from installation, mechanical processes, jig marks and other related defects must be repaired immediately in order for the Warranty to remain in effect.
Protective tapes used in installation must be a “low-tack” quality and must not be left in contact with the surface for more than one (1) month.
Ultralox® must approve all sealants and mastics prior to installation in order for Warranty to remain in effect.